Questions? Call us: +1 760-918-6722

Serial/Parallel

I'm considering the s32128a for a project I'm working on, and I would really like to use the serial interface mode of the ST7565V controller chip to save pins. But I started looking at the data sheet, and it appears that the parallel/serial selection signal isn't brought out to the display's connector. So it looks like there's no way to select serial mode - is that right?

Replies

dtechsupport's picture
dtechsupport
November 9, 2009

You are correct, the P/S select pin from the ST7565 controller is not pulled out on this module. We could prepare a custom module and do so, but either the module size would need to increase or the viewing area would need to decrease.

We do have the P/S option available on the S64128K if that is an option.