Questions? Call us: +1 760-918-6722

DT028ATFT-PTS questions

We recently purchased a DT028ATFT-PTS display (see attached picture).

I have some questions:

  1. Does it include an ILI9341 driver or have I to add it externally?
  2. If it is included. Where is it located?
  3. Do you have a demo of using the DT028ATFT-PTS with an ARDUINO DUE (or an ARDUINO ONE)?

Replies

Derek_Seacomp's picture
Derek_Seacomp
September 17, 2019

Hello,

Thank you for the inquiry.

The DT028ATFT-PTS display module includes the ILI9341 Driver which is located on the display near where the FPC exits. We do not currently have a demo using this part with an Arduino Due or One.

Best,
Derek

rrubiocastil's picture
rrubiocastil
September 19, 2019

Hello Derek, thank you for your response.

I would like to request a pseucode or flow chart to inicialize the display and draw a line using 80 MCU 8-bit bus interface 1.

Thank you

 

engineering_seacomp's picture
engineering_seacomp
September 20, 2019

Hi,

The DT028ATFT uses the ILI9341.

For the initilization code, please see the Design Support Center:

https://www.displaytech-us.com/design-center

It has sample code for init sequence, scope traces, etc.

Part of the sample code shows how to put an individual pixed via PutPixel() and a line via Bar(), but you just write to memory and most likely your graphics library will have these functions that will be similiar.